| Author |
|
funbobbybaby69
Groupie
Joined: April 01 2008
Online Status: Offline
Posts: 88
|
| Posted: July 17 2008 at 09:31 | IP Logged
|
|
|
Does anyone know if you can setup the IRLink to send a "fake" insteon address so PH can pick it up and transfer it to an X10 address?
Thanks
Rob
|
| Back to Top |
|
| |
funbobbybaby69
Groupie
Joined: April 01 2008
Online Status: Offline
Posts: 88
|
| Posted: July 17 2008 at 09:33 | IP Logged
|
|
|
Wow... what a dumbass i am.... No need for PH in that case....
Setting Up X10 Addresses
1) Press & hold the Set button on IRLinc for about 5 seconds, then release
Blue LED will turn off
2) Send the desired X10 address 3 times
Blue LED will begin blinking
3) Press the button on your remote you wish to learn (holding the remote 6-12 inches from the IRLinc IR Receiver)
Blue LED will return to steady on
4) To test, press the button learned on your remote several times. It should turn your X10 products on and off (press & hold to dim or brighten).
Note: IRLinc will only send either INSTEON or X10 for a given programmed IR code. Please refer to the troubleshooting guide for more information.
|
| Back to Top |
|
| |
BeachBum
Super User
Joined: April 11 2007
Location: United States
Online Status: Offline
Posts: 1880
|
| Posted: July 17 2008 at 15:13 | IP Logged
|
|
|
In PH I trigger off an Insteon address which fires my X10 stuff and the reverse.
__________________
Pete - X10 Oldie
|
| Back to Top |
|
| |
Active Topics 
Memberlist 
Search 
Help
Register 
Login
PowerHome Messageboard : PowerHome General
Topic: Can an IR Link send to a "fake" address?
