Active TopicsActive Topics  Display List of Forum MembersMemberlist  Search The ForumSearch  HelpHelp
  RegisterRegister  LoginLogin
PowerHome General
 PowerHome Messageboard : PowerHome General
Subject Topic: Controlling HAI Thermos Post ReplyPost New Topic
Author
Message << Prev Topic | Next Topic >>
threadhead
Newbie
Newbie


Joined: July 04 2006
Location: United States
Online Status: Offline
Posts: 6
Posted: July 04 2006 at 02:29 | IP Logged Quote threadhead
I am desparate to dump (a certain nameless HA software from the boys in
NH) that crashes more than my RC airplane. From what I have read so far,
I'm fairly impressed the PH. But the one thing I really, really want to be able
to do is control my HAI Thermostats.

Can PH control HAI thermostats?

Karl
Back to Top View threadhead's Profile Search for other posts by threadhead
 
TonyNo
Moderator Group
Moderator Group
Avatar

Joined: December 05 2001
Location: United States
Online Status: Offline
Posts: 2889
Posted: July 04 2006 at 11:16 | IP Logged Quote TonyNo
AFAIK, no one has written a macro for these. One 'stat looks to have RS232, so it should be possible.

I wrote some code for an RCS TX15B, which I use.
Back to Top View TonyNo's Profile Search for other posts by TonyNo Visit TonyNo's Homepage
 
dhoward
Admin Group
Admin Group
Avatar

Joined: June 29 2001
Location: United States
Online Status: Offline
Posts: 4447
Posted: July 11 2006 at 00:14 | IP Logged Quote dhoward
Karl,

What kind of interface does the HAI thermostats use for remote control? As Tony stated, the RS-232 ones should be controllable without any problems using the built-in PowerHome serial functions.

Depending upon if the protocol is published and the interface that is used, it may be something that I can build into a later version of PowerHome.

Dave.
Back to Top View dhoward's Profile Search for other posts by dhoward Visit dhoward's Homepage
 
threadhead
Newbie
Newbie


Joined: July 04 2006
Location: United States
Online Status: Offline
Posts: 6
Posted: July 11 2006 at 00:31 | IP Logged Quote threadhead
The protocol is RS-232 and it is published. I'm sure I could write something
to work. But I was hoping that someone else had already done it.

Dave, would you like me to send you the protocol?
Back to Top View threadhead's Profile Search for other posts by threadhead
 
dhoward
Admin Group
Admin Group
Avatar

Joined: June 29 2001
Location: United States
Online Status: Offline
Posts: 4447
Posted: July 14 2006 at 17:02 | IP Logged Quote dhoward
Karl,

Certainly...pass it on to me. If it's something simple, I'll do up a macro.

When I get the plug-in support done, it'll be something that I can then convert over to that format.

Dave.
Back to Top View dhoward's Profile Search for other posts by dhoward Visit dhoward's Homepage
 

If you wish to post a reply to this topic you must first login
If you are not already registered you must first register

  Post ReplyPost New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum